A weighing transducer is a sensor element that converts a gravitational load from a mechanical quantity to an electrical quantity. Therefore, it is the basic link of the electronic scale measurement system, which directly determines and affects the measurement accuracy and working stability. Manufacturers usually need to detect and verify the linearity and repeatability of the selected load cell.
stability (1~3 months) to observe and evaluate its working stability and reliability, for the manufacturer of electronic scales, due to the harsh working environment, damage and frequent replacement of the load cell. In order to find faults and select a new load cell, it is also necessary to test its performance, a test that is often inconvenient to send to the load cell manufacturer. Therefore, it is necessary to provide a simple and practical detection device.
The calibration device consists of hangers, bench racks, weight holders and standard weights which are an integral part of the weighing system. The hangar structure is generally made of stainless steel plate with a thickness of about 2.5mm. However, according to the size of the measured load, the thickness of the plate can be adjusted accordingly, and ordinary steel plates can also be used, but it is better to carry out the anti-rust treatment. In order to ensure the rigidity and reduce the weight of the hanger, you can hit a few on the hanger a small hole. The contact surface of the hanger indenter with the load cell indenter must be spherical for automatic adjustment and in contact with the sensor indenter. The contact between the hanger and the weight hook must be made into a blade or curved surface to ensure that the line of force passes vertically through the center line and is not affected by frictional resistance.
The weights of the hangers and weight hooks are integrated into whole numbers because the weight of the calibration device has a quantitative effect. The structure of the bench frame should pay attention to stability, and the upper plate of the load cell should be flat, with a thickness of not less than 15mm, to ensure that the bearing surface has sufficient rigidity. Weight hooks are generally made into support hooks,
However, the corresponding structural design can also be carried out according to the weight: weight. The weights used are of general measurement accuracy.
Calibration verification method steps.
1. The bench frame should be placed on a stable and inelastic basis, and the plane of the load cell should be basically level.
2. Use the backing plate to fix the load cell on the bench frame.
3. Put on the hanger and press the indenter of the hanger on the indenter of the sensor.
4. Hang the weight bracket on the hanger.
5. Connect the bridge power supply of the load cell, and connect the output to a high-precision millivoltmeter (accuracy should be higher than 70% of the nominal accuracy of the sensor) (the current output value can also be measured if necessary).
6. According to the range of the sensor and the number of points to be measured, gradually load (weight) and unload to the heavy star hook, and record the output data of the sensor. Thereby detecting the sensor's zero output, linear accuracy, complex accuracy and naturally determining whether the sensor is normal advantages and disadvantages.
There is no need to use a code holder to detect tension (force) load cells. Hang the sensor directly on the hook on the back of the load-bearing surface of the bench frame and connect with the weight hook. The rest of the steps are the same as above for the pressure (force) sensor.
The detection device has the following characteristics:
1. The device is simple, takes up little space, and can be made by yourself.
2. Since the standard weight is used as the load, the direct load measurement is adopted, which has the function of automatic centering. Therefore, the measurement accuracy is good.
3. Single-point or multi-point measurement can be performed; loading data, unloading data and long-term on-load simulation tests can be detected. Complete functions, flexible operation, simple and convenient.
4. The device is most suitable for the detection and calibration of small-scale load cells, especially for sensors with an upper limit of 200kg.
Huzhou Liheng Electronic Technology Co., Ltd. is a load cell manufacturer with weighbridge load cells and other products. Welcome to our official website.




