Weighing transducer is one of the more widely used sensors in real life. Many ordinary people can see it at home. The weighing transducer itself has the advantages of strong structure and durability, but it will affect its performance if you do not pay attention to it during use and installation.
For small measurement sensors, they should be protected from shocks, which will affect the accuracy of their future measurements. A large number of measurements of the product itself are very important. Special processing tools should be used when handling. When it falls on the ground, slow down to avoid damage to its internal equipment. At the same time, install the base to be placed. The base should be level and clean. Debris.
Any weighing transducer should avoid overload measurement during use, which will make the deformation of the elastic body irrecoverable and cause permanent damage. In the process of level adjustment, the sensor is better used level to be installed on a uniform horizontal plane to ensure the consistency of its load. The sensor should be fixed with bolts to ensure a certain tightening torque and will not loosen for a long period.
The installation position of the sensor is as far away as possible from high-power equipment, because its output signal is relatively weak, usually in the millivolt level, and it is susceptible to interference. In this case, if the sensor is covered and the output signal is transmitted with a shielded twisted pair, the performance of the sensor will be better. When laying cables, it is also necessary to avoid laying parallel to power cables. When they must be placed in parallel, the distance between them must exceed 50 cm.
